If your bicycle totally tacoed and you need to fix it then you are in a right place. Here we have discussed fixing issues of tacoed bicycle. So, check the article and follow our instructions to solve your problem.


Let’s just jump right into it. At the middle of the wheel looks like, and normally when you are trying to push the Ram.

Pull it one way or the other, you want to take it over on this side, to the left side, normally you’ll tighten the left spokes, but with the right side, normally tighten the right-side spoke there.

Trying to straighten out a severely bent wheel. You ideally want to get the rim as straight as possible before you start dealing with the tension of the folks there.

Actually, what I’m going to do first is really we’re going to just go ahead and loosen the spokes here on this side.

So, we’re going to push this rim over that way in order to do that, we loosened these, you know, the spokes here at the point.

You have to do it correctly to true your tacoed bicycle wheel.

This rim and that little, that little point right there, it’s going to actually have to come. You know, it’s got to flex over probably, you know, half an inch, three-quarters of an inch past where it needs to be.

Then once you push it back that far, it’s going to release back, and then we’ll have a straight ramp.


But in order for it to move over that far, we’re going to have to loosen up the spokes. Right. Right. Okay. So, what I’ve done here on the side of the rim.

I made a couple of decisions. Little arrows on the location of where I’m going to basically bend it over. Basically, right here is kind of, that’s where it kind of peaks over.

That’s on that side. That’s my arrow there on this side, you know, it’s kind of work peaks and then that’s the other arrow there.

You have to need to loosen basically all the spokes. On this side of the rim between the two arrows there. So normally I don’t Mark them, but you know, if you’ve never done this, you may smack make it a little easier.

You know, you just kind of Mark the spot there and then, you know, that’s where we’re going to press on it. So go ahead and back the spokes off and get ready to press it into place.

No, the peak is there. So normally I’ll just push on either end, especially here where it’s kind of pushed over that side. I’ll just plant this little two by four. It’s kind of an old ratty two by point is my work band. Yeah.

You don’t want to just push it, flex it, you know, put some of your weight into it, but not so much where it just. Tacos hit and destroyed it. That side looks pretty good.


Anyway, I guess that’s going to wrap this article up and any comments, questions, just are sure to leave them down there in the comment section, and finally thanks for reading our how-to guideline.

Leave a Reply

Your email address will not be published. Required fields are marked *